Re: What a HKS 7M Metal Head Gasket Looks Like (mhg)
Sun, 02 May 2004 14:23
Gobble gobble
That is much better.
As I am not going to remove and completely disassemble the engine to deck my block (unless all else fails), tyhen I wont get to see one of these puppies in the flesh
Thanks anyway, it look nice ....
PS On another note. I had to machine the discs slightly and take 7mm off the back of the MS65 hubs to get sufficient clearance around the LCA and ball joint. It was just too close otherwise. Also, the RA60 upper spring perches (on the front struts) are a different dia to the MA61 units !!
Sun, 02 May 2004 14:23
It was just too close otherwise. Also, the RA60 upper spring perches (on the front struts) are a different dia to the MA61 units !!
