Toymods Car Club Inc: Tech & Conversions => ra28/xt130 camber adjuster/ shocks/springs

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » ra28/xt130 camber adjuster/ shocks/springs Show: Today's Posts :: Show Polls Email to friend

Author

Topic

dorikin
Regular

I supported Toymods

Location:
NE Melbourne
Registered:
May 2002

Re: ra28/xt130 camber adjuster/ shocks/springs	Wed, 04 September 2002 06:51

yes, the LN106 caliper bolts directly to the corona strut with no mods. use the XT130 hub, and the pug disc bolts to it just like the stock XT130 discs, once the holes are enlarged, or better still, slotted outwards about 2mm... you will then find that to ensure the disc spins true, in the center of the caliper, the caliper needs to be space backwards by about 1mm. i simply used some 1mm washers, and the bolts were the perfect length. the actual bolts i used are longer than the bolts that hold on XT130 caliper, so i used a spare set of bolts that are used to bolt the strut to the steering arm... it really is a "bolt on" upgrade, once the discs are machined to suit. i had my discs turned down to the 266mm diameter, and the bolt holes slotted to be correct size. while i was at it, i decided some slotted discs would be nice, so i had that done too!!! [Report message to a moderator]

Current Time: Sat Aug 2 19:56:30 UTC 2025

Total time taken to generate the page: 0.0043368339538574 seconds

.:: Contact :: Home ::.