Toymods Car Club Inc: Tech & Conversions => Different Sprinter Engine Conversions.

Toymods Car Club
www.toymods.org.au

F.A.Q.

Home

Members

Toymods » Tech & Conversions » Different Sprinter Engine Conversions. Show: Today's Posts :: Show Polls Email to friend

Author

Topic

Bill Sherwood
Forums Junkie

Location:
Brisbane / Gold Coast
Registered:
May 2002

Re: Different Sprinter Engine Conversions.

Tue, 11 May 2004 05:16

Youngy wrote on Tue, 11 May 2004 11:03

That Altezza 3SGE just did not want to go in really either. I think that had to cut to much in order to make it fit - bad option when there are others that have already been listed that are a better fit.

Like this? Smile

http://www.billzilla.org/ae863sgebay1.jpg

As Norbie said though, it needed a little cut out of the bottom of the bonnet and the crossmember had to be lowered 10mm with spacers. The only otehr change to the crossmember was to weld on the Altezz engine mounts, not that hard to do.
We could have used either a remote vacuum booster or a smaller one, or even put a small bump in the existing one I think.
But, it was a bugger of a job and I wouldn't recommend it at all.

[Report message to a moderator]

[Message index]

-=] Back to Top [=-

Current Time: Tue Nov 4 08:28:58 UTC 2025

Total time taken to generate the page: 0.0044689178466797 seconds

.:: Contact :: Home ::.