Toymods Car Club Inc: Tech & Conversions => Frame strengthening with foam!

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » Frame strengthening with foam! Show: Today's Posts :: Show Polls Email to friend

Author

Topic

clubagreenie
Forums Junkie

Location:
1st street on the right
Registered:
November 2002

Re: Frame strengthening with foam!	Thu, 13 May 2004 07:28

Yes I have heard of it being done. Back in the 60's my father rallied renault's and this was standard. Be prepared for rust though as the foam is open cell (full of bubbles). Any water or condensation that gets in, and it will, will soak into it pooling in the lowest areas. Also adds weight too I suppose. Does work a treat though, and if it was track only or driven only in dry or not a long term proposition then go for it. It's available from fibreglass suppliers such as Fibreglass Material Suppies on Station Rd Seven Hills. A 2 part mix you also have to be careful as the expansion can deform panels if the cavity is over filled and not enough holes are available for expansion. Best to fill a bit at a time. BTW it's also great stuff to make f/glass moulds from. Not sure of the price either. If it was going into a drifter, definately an improver. I'd still go the roll cage though. Properly engineered and braced to the suspension points, it too will help in other ways (also for just in case). [Updated on: Thu, 13 May 2004 07:32] [Report message to a moderator]

Current Time: Sat Aug 9 21:54:51 UTC 2025

Total time taken to generate the page: 0.0035879611968994 seconds

.:: Contact :: Home ::.