| Author | Topic |
|---|
I supported Toymods
Location:
Australia
Registered:
November 2003
|
|
Re: 1UZFE to MA61 conversion - specific issue
|
Sat, 15 May 2004 23:00
 
|
 |
Dave, 3 of the 4 pipes will have to venture on the outside of the steering shaft.
Only number 8 can go between the block and the shaft.
I temperarially just took a chunk out of the headers to clear the steering, so I have less than 1"sq of flow there (yes, it sucks, but it was necessary)
I definately plan to get extractors, and there is a dickload of room between the steering shaft and the chassis rails, which is where 3 of the 4 pipes shall go.
However, the cost of extractors is guestimated to be around and over the $1500 mark, not including the rest of the system.
If I get my car running on my first RnR, then I'll send my car to the exhaust shop to build the extractors while I'm up here again.
As for more pics, check my thread, they are all there.
I have no others though.
Ask me in 3 weeks when I'm home, and I can take specific measurements and photos for you.
|
|
|
