| Author | Topic |
|---|
Location:
Lost in the K hole
Registered:
May 2002
|
|
Re: mesauring tools
|
Wed, 19 May 2004 06:50
 
|
 |
| kingmick wrote on Wed, 19 May 2004 16:30 |
you must be using all studs and billet caps, had the tunnel line bored, the bores done using a deck plate, crack tested the block. test fit about ten times, hand blended the pistons,linish the crank.
|
and as the machine shop is going to be doing all this ^^^^^ work, you can pretty much leave measurement and blueprint tolernces in their hands.
plastigauge, verniers, and feeler gauges should get you through the rest of the build ok. (unless you start getting fancy, and doing your own deck height calcs, checking valve guides etc). it realy depends how much you expect to do yourself, and how much youre prepared to relinquish control to the machinist.
|
|
|
