Toymods Car Club Inc: Tech & Conversions => 4age bigport

Toymods Car Club
www.toymods.org.au

F.A.Q.

Home

Members

Toymods » Tech & Conversions » 4age bigport - whats the biz with this miss?! Show: Today's Posts :: Show Polls Email to friend

Author

Topic

FKN16V
Forums Junkie

Location:
NSW, East Coast
Registered:
July 2003

Re: 4age bigport - whats the biz with this miss?!

Sun, 23 May 2004 12:07

Bobski wrote on Sun, 23 May 2004 21:32

fuel problem ey?

do u guys know what fuel pump is normaly used when converting to 4age? there is one strapped to the side of my tank which looks like a long tube about as thick as a fluero tube and its rusted to shit, ive been meaning to get an efi tank cos the fuel surge gets terrible with any less then a third tank fuel under heavy cornering but i hope thats the problem...

does any1 know the exact fuel pressure required?

what are my chances of geting an efi tank for a sprinter?

is there any others that fit?

thanx

Fuel pressure should be between 38/44 psi at idle(with no vacumm),

VL commodore external pump or open up standard tank and weld in vn commodore baffles and pump, lift pump into surge tank then a proper efi pump after the surge tank, efi sprinter tanks are around but rarely.

All cost about the same,depending on where/who you buy the gear from, either find standard sprinter efi tank or cut open your standard tank (like mine is) and weld in the vn baffles and pump, theres not a lot of room under the sprinter to install a surge tank so they usualy end up in the boot.

Do a search for ae86 efi fuel setups, it been covered many times before, but 25psi is way too low?

[Report message to a moderator]

[Message index]

-=] Back to Top [=-

Current Time: Fri Jan 3 14:29:19 UTC 2025

Total time taken to generate the page: 0.0097839832305908 seconds

.:: Contact :: Home ::.