| Author | Topic |
|---|
Club Member
Location:
sydney
Registered:
May 2002
|
|
Re: 4age parts identify help please?
|
Mon, 24 May 2004 10:41
 
|
 |
1) as explained above both are sensors for the ecu, one for cold start the other is for engine temp, BOTH must be plugged on to the loom, get the pinouts from the Tech Docs section so you can do a continuity test to make sure the cut wires are the the ones you need to solder the plug back on to.
2)one goes to the charcoal canister the other goes to the aircon idle up adjuster valve.
3)block them off, theyre not needed, the two that you need to connect to the cooling system for idle up control are off to the left in that picture and go straight down, it dosent really matter which way round you plumb them either from memory.
4)you dont need to connect anything up there at all, in fact id pull the sensor out and buy a more accurate aftermarket electric temp gauge, throw its sender in there instead of the vacume port.
[Updated on: Mon, 24 May 2004 10:44]
|
|
|
