Location: Brisbane / Gold Coast
Registered: May 2002
Re: 4AGTE head??
Mon, 09 September 2002 12:22
Yes, the RWD inlet manifold will bolt-on okay, but of course only to the big port head. It's a bit tight up against the head without the TVIS plate, but it can be done.
If you wre to make one from scratch, I'd cut the plenum off a FWD one and weld on a bigger plenum, with the TB where you want it to go.
And yes, the combustion chambers are exactly the same; the difference in compression is done with different piston top heights.
Mon, 09 September 2002 12:22
