Toymods Car Club Inc: Tech & Conversions => Running cables for stereo in ra6x / ma6x

Toymods Car Club
www.toymods.org.au

F.A.Q.

Home

Members

Toymods » Tech & Conversions » Running cables for stereo in ra6x / ma6x Show: Today's Posts :: Show Polls Email to friend

Author

Topic

Stefan
Forums Junkie

Location:
Hobart, Tas
Registered:
May 2002

Re: Running cables for stereo in ra6x / ma6x

Wed, 11 September 2002 07:46

justcallmefrank wrote on Wed, 11 September 2002 14:06

Okay, in my Celica, I ran it following the wiring loom out the side of the engine bay, through the wheel arch, through the grommet they have for coming into the cabin, then mine runs down the side to the "tunnel" along the chassis rail then under my seat where my amp is.

You mean on the passenger side, through the hole where the wiring loom dissapears behind the battery (ra65, ra60 is other side i think)? great idea. Did you take the wing off to do it though?

Dabbid: I'll try to use an existing hole if I can, but I will drill a hole if I have to. The power through firewall part is the only bit haven't really figured out. I was going to run the power up the passenger side then accross behind the back seat to the amp whihc is on the driver side in the hatch in that funny storage compartment. The rcas will go on the diver's side of the trans tunnel, then under the back seat to the amp, and the speaker wiring will either go down the trans tunnel too or on the dirvers side loom tube. It is inevitable that the power will cross the speaker wirirng and oints, but i guess if I do it at 90* it will be ok. Does this all sound alight?

Do I have to keep the RCAs away from ALL power, or just the main feeds from the battery?

[Report message to a moderator]

[Message index]

-=] Back to Top [=-

Current Time: Tue Jul 22 21:28:35 UTC 2025

Total time taken to generate the page: 0.0054678916931152 seconds

.:: Contact :: Home ::.