Toymods Car Club Inc: Tech & Conversions => st185 injectors into st162

Toymods Car Club
www.toymods.org.au

F.A.Q.

Home

Members

Toymods » Tech & Conversions » st185 injectors into st162 Show: Today's Posts :: Show Polls Email to friend

Author

Topic

RWDboy
Forums Junkie

Location:
South Australia
Registered:
July 2002

Re: st185 injectors into st162

Tue, 08 June 2004 02:17

FWDboy wrote on Mon, 07 June 2004 22:00

I disagree - see above post Smile

If you can lean out the mixture then you would gain power with the factory injectors...it would be a waste of money *unless* you are flowing a bugger-load more air than the factory engine.

I just thought I'd clarify this in case you thought that i meant a leaner mixture won't make more power.

What I mean, is that if you are able to lean out the mixture using something like a piggy back ECU, then regardless of whether you have bigger injectors or factory injectors, you will gain the same amount of power. In fact, you'll probably gain less power with the bigger injectors - again - due to the poor atomisation of such a short open cycle.

I re-read what I wrote and I could see it was easily misinterpreted.

[Report message to a moderator]

[Message index]

-=] Back to Top [=-

Current Time: Sat Feb 1 21:50:27 UTC 2025

Total time taken to generate the page: 0.007296085357666 seconds

.:: Contact :: Home ::.