Toymods Car Club Inc: Tech & Conversions => Running cables for stereo in ra6x / ma6x

Toymods Car Club
www.toymods.org.au

F.A.Q.

Home

Members

Toymods » Tech & Conversions » Running cables for stereo in ra6x / ma6x Show: Today's Posts :: Show Polls Email to friend

Author

Topic

Stefan
Forums Junkie

Location:
Hobart, Tas
Registered:
May 2002

Re: Running cables for stereo in ra6x / ma6x

Wed, 11 September 2002 15:41

justcallmefrank wrote on Wed, 11 September 2002 23:00

Yeah, the battery on the RA60 is on the drivers side, but it would be the same so the chassis is compatible for left/right hand drive.

Huh? I must be tired. I guess you're saying whatever side the battery is on there will be hole for the loom. Fair enough. I wonder why the Supra apparently has a grommet on the passenger side but the celi doesn't?

Did you take off the wing to run the cable?

Quote:

My RCA cables run down the centre of my car, so they out the way. Where my speaker cables run into my doors, they run high, then directly down the side of the car, whereas I ran the power cable lower to keep the interference down.

Did you actually run the speaker wires up near the headlining, or just higher than the power buy still under the bottom of the door? Sorry 'bout the stupid questions, i'm knackkered.

The amp is going in the funny storage compartment opposite the jack, on the driver's side. Only place it will go really. I have my stacker there too. The amp is only 25 rms or so x4, but won't fit under the seat. I can't screw it to the back of the back seat because I put the seats down to carry stuff.

[Report message to a moderator]

[Message index]

-=] Back to Top [=-

Current Time: Sat Jul 19 16:40:17 UTC 2025

Total time taken to generate the page: 0.0074021816253662 seconds

.:: Contact :: Home ::.