| Author | Topic |
|---|
Location:
Adelaide, drift capital
Registered:
May 2004
|
|
Re: 4agze head removal
|
Wed, 09 June 2004 09:32
 
|
 |
| HighRolla wrote on Tue, 08 June 2004 23:24 |
Invest in a decentish 1/2 inch drive and breaker bar 
|
I have a decent 1/2 inch drive set, but the problem is that the passage to the bolt is very narrow, and it aint possible to get a 10mm 1/2" drive socket onto the bolt head, it hits the side of head.
This is probably why toyota created an SST for removing the tite mfs.
I've been using a 10mm 3/8" socket attached to an extension, attached to my torque wrench, and then a bmx frame on the end for lots of extra leverage!  .
I am a little concerned using an oxytorch on my head
Thanks for your help
Cheers,
Joel
|
|
|
