| Author | Topic |
|---|
Toymods Board Member
I supported Toymods
Location:
Turramurra, Sydney.
Registered:
May 2002
|
|
Re: crank angle sensor (4age)
|
Sun, 18 July 2004 21:23
 
|
 |
You can chop off 3 of the teeth on the top wheel in the dizzy, the 2, 3 & 4 cylinders teeth, leaving of course the no. 1 cylinders TDC reference. As far as I understand, the GZE CAS has only one tooth on it's wheel but 2 sensors sitting opposite each other, plus the same 24 tooth single sensor wheel underneath, but the microtech is only wired up to one of the top sensors, so with your dizzy modified as above, you should be sweet.
That's what I did to mine to use with a microtech, but now I'm going to use an Autronic ECU & CDI unit instead, & that also can be wired up to the standard dizzy with this mod.
|
|
|
