Toymods Car Club
www.toymods.org.au
F.A.Q. F.A.Q.    Register Register    Login Login    Home Home
Members Members    Search Search
Toymods » Tech & Conversions » 4efte into Paseo

Show: Today's Posts  :: Show Polls 
Email to friend 
Return to the default flat view Create a new topic Submit Reply
AuthorTopic
ranshz
Occasional Poster


Location:
Nowra
Registered:
July 2004
Re: 4efte into Paseo Tue, 20 July 2004 01:30 Go to previous messageGo to previous message
I'm thinking of the same thing for my Paseo. Take a look at:

http://www.paseopimp.com/main.php

and here's a paste from the site:

It is physically a direct bolt in. The seo halfshafts will work, the seo trans will work. It's best to use the 4e ecu also, but that means a custom harness so the rest of your car's electricals still work. You also need the 4e harness, ignitor, map sensor, and coil. These are the only components not directly connected to the engine that you should also have for a less painful swap. If you have an auto and wanna switch to a manual then, you either need a hella good electrician, or you need a manual trans cowl (under dash) harness for your seo also. These are very expensive from the dealer (early 92-650ish, late 92-95 900ish). This makes the painful wiring easier. I'm not sure about the 2g harnesses. If you have an auto and wanna keep it, you need a 4e computer from the ep91 starlet, as that's the only turbo version that was available with an auto trans. That would be 96 or newer starlet. The power steering pump is diff (fyi). The starlet trans has slightly different gear ratios than the seo (closer), and a 4.31 final drive as opposed to the seo's 3.9. The starlet trans also has a 212 mm pressure plate, seo 200mm. If you go with the starlet trans (recommended) you can use an aftermarket clutch for the celica. The sparkplug wires are the same, except if you get a set for the seo you won't get the cable from the distributor to the coil, as the seo coil is integrated.
The hardest part about the wiring is where the 4e harness goes to the underhood fuse box, and where the engine harness interfaces with the cowl harness. The plugs are different, the wire colors are different, and every starlet wiring diagram I have found only has the engine harness wiring, and not the cowl or fuse box wiring.
The ASP, or Diaboliqeracing underdrive crank pulley will work on the 4e. The 4e downpipe/o2 sensor housing will not bolt directly to the seo exhaust, but a coupler isn't hard to make.
The starlet has a hi/lo boost switch, but if you don't get a clip you won't get this switch. If you don't have it, you can wire your own, or just delete it. The car will stay on high boost, which is .65 BAR or about 9.5 psi. This is a good thing, but it means you can only use premium gas. The fuel mileage is still good, if you don't flat foot it everywhere you go. That was hard for the first few weeks. I had to get gas about every other day. LOL. If you gut the stock cat/downpipe/o2 sensor housing before installation the car will run better, but this is illegal (disclaimer). Or wicked eps sells a stainless downpipe/cat eliminator.
The computer fuel cut is at 14 psi, if you want to exceed this you will need a fuel cut defenser. HKS sells these for about 150, or check e bay. The paseo fuel pump will support the stock boost, not sure how much over stock it will support, but fuel is very important to turbo engines. FUEL AND FUEL RATION IS VERY VERY IMPORTANT TO TURBO ENGINES.
There are a multitude of tuning parts available for the starlet engine. Everything from fmic kits, to turbo upgrades, to bovs, to piggy back fuel computers and ecu replacements.
I plan on making a resource list of all of the starlet engine parts I have found, and where to get them.
If you plan on doing the 4e-5e hybrid the crank will end up being the weak link, the 5e crank is not as strong as the 4e crank. I don't have any specifics on this as to how much.
I plan on boosting my 4e to 12-13 psi with the help of a turbo xs standard boost controller and apexi safc. Although the fuel cut is at 14 psi, and you can go even higher with proper fueling, I have heard that about 12 psi is about the top of the efficiency curve for the stock ct9 turbo. After that it's just an industrial strength heat gun.
This is all that I can think of right now, it's gettin late.
If you guys like this, sticky it, if not dump it. It just seems we answer the same questions over and over again. Well that's my editorial. Peace Pimps. Oh, and get booooooooosssssssssssttttttttt.

-------------------------------------------------- ---

Hope this all helps
  Send a private message to this user    

SubjectPosterDate
Read Message   4efte into Paseo HennFri, 02 April 2004 16:51
Read Message   Re: 4efte into Paseo FKN16VSat, 03 April 2004 01:06
Read Message   Re: 4efte into Paseo  ranshzTue, 20 July 2004 01:30
Read Message   Re: 4efte into Paseo sideshowTue, 20 July 2004 13:36
Read Message   Re: 4efte into Paseo ranshzWed, 21 July 2004 12:50
Read Message   Re: 4efte into Paseo EVOSTiWed, 21 July 2004 11:21
Read Message   Re: 4efte into Paseo sideshowWed, 21 July 2004 12:40
Read Message   Re: 4efte into Paseo dsp_26Wed, 21 July 2004 12:41
Read Message   Re: 4efte into Paseo EVOSTiThu, 22 July 2004 09:42
Read Message   Re: 4efte into Paseo ranshzThu, 22 July 2004 10:54
Read Message   Re: 4efte into Paseo 7M-BrisbaneThu, 22 July 2004 14:55
Read Message   Re: 4efte into Paseo MR. 2Thu, 22 July 2004 22:45
Read Message   Re: 4efte into Paseo ranshzFri, 23 July 2004 01:04
Read Message   Re: 4efte into Paseo Rod83Fri, 23 July 2004 04:07
Read Message   Re: 4efte into Paseo 10sec_rx7Fri, 23 July 2004 05:11
Read Message   Re: 4efte into Paseo ranshzFri, 23 July 2004 10:34
Read Message   Re: 4efte into Paseo HennFri, 23 July 2004 14:51
Read Message   Re: 4efte into Paseo twincam_ke20Fri, 23 July 2004 23:47
Read Message   Re: 4efte into Paseo 10sec_rx7Sat, 24 July 2004 03:03
Read Message   Re: 4efte into Paseo questSun, 25 July 2004 12:26
Read Message   Re: 4efte into Paseo 10sec_rx7Sun, 25 July 2004 22:08
Read Message   Re: 4efte into Paseo ranshzMon, 26 July 2004 22:02
Read Message   Re: 4efte into Paseo 10sec_rx7Mon, 26 July 2004 23:01
Read Message   Re: 4efte into Paseo questTue, 27 July 2004 04:13
Read Message   Re: 4efte into Paseo 10sec_rx7Tue, 27 July 2004 04:29
Read Message   Re: 4efte into Paseo ranshzThu, 29 July 2004 21:39
Read Message   Re: 4efte into Paseo 10sec_rx7Thu, 29 July 2004 21:53
Read Message   Re: 4efte into Paseo ranshzWed, 18 August 2004 05:03
Read Message   Re: 4efte into Paseo toyboyMon, 10 January 2005 09:17
Read Message   Re: 4efte into Paseo ranshzMon, 10 January 2005 22:30
Read Message   Re: 4efte into Paseo festerTue, 11 January 2005 08:18
Read Message   Re: 4efte into Paseo sideshowTue, 11 January 2005 12:02
Read Message   Re: 4efte into Paseo toyboyTue, 11 January 2005 17:11
Read Message   Re: 4efte into Paseo EnrageSat, 11 June 2005 06:10
Read Message   Re: 4efte into Paseo mrshinSun, 12 June 2005 11:21
Previous Topic:what is the best engine for a ke70 corolla
Next Topic:4age rwd top water outlet bypass tube sealing

Goto Forum:
-=] Back to Top [=-

Current Time: Thu Sep 19 01:37:43 UTC 2024

Total time taken to generate the page: 0.0058219432830811 seconds

Bandwidth utilization bar

.:: Contact :: Home ::.

Powered by: FUDforum 2.3.8
Copyright ©2001-2003 Advanced Internet Designs Inc.