| Author | Topic |
|---|
Club Member
Location:
sydney
Registered:
May 2002
|
|
Re: wanted 4AC dissy or modula
|
Mon, 23 September 2002 06:19
 
|
 |
Ive got a couple of 4AC dizzys here you can pick what one you want $50 each.
Hmm Im not sure what you mean Hunty? are you planning on using a 20V bottom end??? you may want to consider changing the piston...although it would be possible to set the timing at the cams so that the valves closed a little earlier and there-by had no chance of hitting the piston (unless the cam belt breaks as using the GE block with the C head no longers means a no interferance system) it may be better to get some pistons made up..if you got forgies then you could boost it as well..for no other reason than because you can! before everyone jumps in!!  just make sure you get them made with the right size gudgeon pin to suit the block you want to run.
Elmo, where did you get your extractors made and how much did they cost?. you could try running a bigger carb like a 32/36 weber or better still but probhably overkill is the 36/36 IDF, youve allready got the extractors so it will be easier to fabricate something to fit the bigger carb.
|
|
|
