| Author | Topic |
|---|
Club Member
Location:
sydney
Registered:
May 2002
|
|
Re: Wolf3D Ver 4 Settings
|
Mon, 09 August 2004 11:00
 
|
 |
its for a 4age, they were all set via laptop on the dyno, the rate i gave is for pre start, i.e when you provide power to the ecu before cranking. are you asking for the scale? because the scale adjusts the overall values but the comp rate is an individual setting that is applied to the ms rate at each step regarless, i.e if your at 2.0ms and the comp adds 1.0ms at Xtemp then you get 3.0ms and if your at a higher ms rate it still applies the same dose untill the cut off rpm ... then the rest is to do with the decay rate and weither is set at linear or the other settings.
|
|
|
