Toymods Car Club Inc: Tech & Conversions => 20V ST what should be replaced before installation?

Toymods Car Club
www.toymods.org.au

F.A.Q.

Toymods » Tech & Conversions » 20V ST what should be replaced before installation? Show: Today's Posts :: Show Polls Email to friend

Author

Topic

mrshin
Forums Junkie

Location:
Montrose, VIC
Registered:
May 2002

Re: 20V ST what should be replaced before installation?	Sat, 14 August 2004 11:28

Water pump, timing belt, use all new water hoses, check out the starter+alternator, get rebuilt if at all questionable, replace the rear main, usual stuff! Obviously you also replace crap like oil, plugs, etc.! [Report message to a moderator]

Send a private message to this user

[Message index]

Subject Poster Date

Read Message 20V ST what should be replaced before installation? jkvsnn Sat, 14 August 2004 11:19
Re: 20V ST what should be replaced before installation? mrshin Sat, 14 August 2004 11:28
Re: 20V ST what should be replaced before installation? emmac Sat, 14 August 2004 13:20
Read Message Re: 20V ST what should be replaced before installation? Alainve Sun, 15 August 2004 13:35
Re: 20V ST what should be replaced before installation? jkvsnn Mon, 16 August 2004 11:54
Re: 20V ST what should be replaced before installation? ._T_. Mon, 16 August 2004 22:35
Read Message Re: 20V ST what should be replaced before installation? Ben Wilson Tue, 17 August 2004 03:50
Re: 20V ST what should be replaced before installation? kenno Thu, 19 August 2004 22:21
Re: 20V ST what should be replaced before installation? juzzo84 Sat, 21 August 2004 12:57

Previous Topic: Good buy AE101 4AGZE
Next Topic: fuel tank conversion in a 22

-=] Back to Top [=-

Current Time: Thu Jul 31 00:57:27 UTC 2025

Total time taken to generate the page: 0.0049118995666504 seconds

.:: Contact :: Home ::.

Powered by: FUDforum 2.3.8
Copyright ©2001-2003 Advanced Internet Designs Inc.