Toymods Car Club Inc: Tech & Conversions => AE82 oil cooler on a 20V?

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » AE82 oil cooler on a 20V? Show: Today's Posts :: Show Polls Email to friend

Author

Topic

Leighp
Forums Junkie

I supported Toymods

Location:
NY
Registered:
May 2002

Re: AE82 oil cooler on a 20V?	Mon, 16 August 2004 04:25

first difference was that i could notice that the oil was not shearing as much (shearing being where it burns and blows out as smelly smoke). Second difference is that i can run a thinner oil and the car performs better (due to less heat and shearing again). In order to install the cooler i ripped off all the fittings around the filter, (there is a 2 part piece that attaches to the filter then the block, that is held on by 4 bolts, undo them then with a 27mm socket take off the bolt holding what ever that other piece is and inturn that piece will come off also. Then put the 4age feeder straight on, use the special double threaded bolt and attach a filter. then fit lines appropiately. as for the sump there are many ways about it, I put a fitting in after drilling a small hole, then hitting it with a taper punch, then i added the same size thread and screwed in a flare fitting that will be sweet in my return hose. Others use a double bolt, what ever suits you. There it is Sorry about the lack of knowledge of the part names, but i tried....all i know is that the car runs alot better hunty i have a sump that i can sell to you that should bolt straight on........ [Report message to a moderator]

Current Time: Mon Jun 2 15:18:23 UTC 2025

Total time taken to generate the page: 0.0079400539398193 seconds

.:: Contact :: Home ::.