| Author | Topic |
|---|
Location:
Gold Coast
Registered:
January 2003
|
|
Re: 3SGTE with S-53
|
Tue, 17 August 2004 13:00
 
|
 |
yeah well what i did was that u should get a starter with your half cut from the gt-4!
On the bell houseing of the 3s-ge s-53 box fromthe out side and box side you'll see the square/flat area that back the starter when it on the 3s-ge (just above the slave cylinder). it will have two pre drill holes of about 5-7mm these are PERFECTLY lined up for the gt-4 starter, all u need to do is go to the local hardware get a 10mm (about that) drill bit, a tap to suit the drill, (or a drill bit to suit the tap, lol) and then ask for two high tensile bolts about 30-40mm long and maybe some washers to suit (just use ones laying around!). then drill out thoes pre-drilled holes from the factory and then tap them and check if the bolts turn in nice and true!
Then from the engine side of view u can see some circle's that out line the size of the hole u need to make of the starter to fit threw! it is quite thin there, cause Toyota would of made a billion of them bell housings and just if needed one for a 3s-fe, gt-4 etc just punched out a hole for it!, did it with a compass and simple ruling to get a middle piont and used a hole saw, piece of piss!
Nezza 
|
|
|
| | Subject | Poster | Date |
|---|
 |
3SGTE with S-53
|
acreese | Wed, 26 May 2004 10:30 |
|
Re: 3SGTE with S-53
|
Aust162 | Wed, 26 May 2004 10:37 |
|
Re: 3SGTE with S-53
|
acreese | Wed, 26 May 2004 10:55 |
|
Re: 3SGTE with S-53
|
Dreamer | Mon, 16 August 2004 07:11 |
|
Re: 3SGTE with S-53
|
wiso | Mon, 16 August 2004 10:07 |
|
Re: 3SGTE with S-53
|
Dreamer | Mon, 16 August 2004 16:09 |
|
Re: 3SGTE with S-53
|
GT4BOOSTD | Tue, 17 August 2004 07:48 |
|
Re: 3SGTE with S-53
|
3S-GE_Man | Tue, 17 August 2004 13:00 |
|
Re: 3SGTE with S-53
|
Dreamer | Thu, 26 August 2004 08:19 |
