Author | Topic |
I Supported Toymods
Location: Sydney
Registered: December 2002
|
Re: Entering Security code?!?!
|
Sun, 29 August 2004 01:39
|
|
This is the info from my ST185 manual but I assume the ST184 would have the same radio.
1) Make sure the radio is turned off and with ignition switch in the acc position.
2) Hold "1 (APS)" and "6" and push and hold in the "PWR-VOL" button until "SEC" appears on the display.
3) Press the "1 (APS)" button while holding the "TUNE ^" button. This should make the display read "---"
4) Input your security code by pressing the "1 APS", "2 (MTL)" and "3 Dolby" buttons repeatedly. Pressing 1 sets the first digit, 2 sets the second, 3 for the third digit.
5) When your security code is displayed on the unit press and hold the "SCAN" button until "SEC" appears on the display. "SEC" will go off to indicate the system is set.
|
|
|