Toymods Car Club Inc: Tech & Conversions => Anyone running a rear coil setup that is not captive ?

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » Anyone running a rear coil setup that is not captive ? Show: Today's Posts :: Show Polls Email to friend

Author

Topic

On Probation

Location:
North East NSW
Registered:
December 2002

Re: Anyone running a rear coil setup that is not captive ?	Tue, 31 August 2004 04:50

drill a hole in the spring platform and wire the spring to the bottom of the spring seat, i'll be doing this in my ke25 when i put my new front suspension setup in next week. i'll be wiring in two places, close to the end of the coil, and 180 degrees from this. be careful you don't end up wiring a piece of the spring that's sposed to compress and expand, you'll just break the wire. if the spring compresses down onto the wire, you'll crack the coil metal the rally car that my springs came out of used to run the same setup i intend to use, but with cable ties instead of wire my exhaust guy also had the suggestion of welding a piece of large diameter pipe, or even just 4 stopper prongs, coming down from the top spring seat. i personally would only need about 1.5" of stopping metal, you may need more or less. this way the spring can bounce about all it wants but it's never going to fall out. unsure of legalities, i think the pipe may have more chance of getting engineered (if required) than prongs [Report message to a moderator]

Current Time: Wed Sep 24 05:09:51 UTC 2025

Total time taken to generate the page: 0.0043489933013916 seconds

.:: Contact :: Home ::.