Author | Topic |

Location: Kita-Ku, Sapporo, Japan
Registered: January 2003
|
Re: 3k-C timming and dwell angle setttings
|
Sat, 18 September 2004 16:35
|
 |
set the valve clearances when hot to be a tight sliding fit for:
0.2mm intake, and
0.3mm exhaust.
this will be fine, but sometimes you may want to go a little smaller.
timing, start at about 12 degs, unless you are running ULP and then maybe a little less..
dwell angle?
smaller points gap = larger dwell = longer time for coil to charge.
set it to a sliding fit for 0.25mm. you could go to 0.2, but the you'd have to check it all the time.
0.4mm if you will never check it again 
Cya, Stewart
|
|
|