Location: I renounced punctuation
Registered: May 2002
Re: Supra JZA80 clutch master and slave cylinder bore sizes
Mon, 20 September 2004 01:08
At the moment I'm using MX13 master and MA61 slave cylinders. It looks very much like the fingers are bent suggestive of too much travel. The thrust bearing wear pattern on the fingers is also quite wide. I'm going to take all 3 pressure plates to the local clutch guru and see what he has to say.
I'm sick of blowing cluches - this is number 3! I only did 3 laps yesterday (only highlight was chasing down a 400hp XY GT). Very frustrating - it's driving me to tears.
If you guys can't dig up the details, don't worry too much. I'll just put in an adjustable 'stop' to limit pedal travel.
Mon, 20 September 2004 01:08
