F.A.Q.    Register    Login    Home Members    Search

Toymods » Tech & Conversions » Gen2 to Gen 3 Turbos Show: Today's Posts  :: Show Polls  Email to friend

Author	Topic
gold28 Forums Junkie Location: Madrid - Spain Registered: August 2002	Re: Gen2 to Gen 3 Turbos Wed, 22 September 2004 11:55 I did a write up on the differences some time back, see this link Essentially the exhaust side is all the same and the inlet is different. They will bolt up so long as you get the cast alloy pipes on the AFM side of the compressor. All the coolant and oil lines are the same, so no worries there either. The gen3 turbos seem a bit wider, so if your rear turbo is close to your steering box or master cylinder it may cause issues. i didn't notice this until I bolted them in and couldn't get a heat shield on. [Report message to a moderator]

	Subject	Poster	Date
	Gen2 to Gen 3 Turbos	BLK1GGTE	Thu, 16 September 2004 08:25
	Re: Gen2 to Gen 3 Turbos	Ribbo	Thu, 16 September 2004 08:37
	Re: Gen2 to Gen 3 Turbos	Fattony	Thu, 16 September 2004 08:42
	Re: Gen2 to Gen 3 Turbos	ddeane	Fri, 17 September 2004 00:55
	Re: Gen2 to Gen 3 Turbos	Fattony	Fri, 17 September 2004 08:24
	Re: Gen2 to Gen 3 Turbos	gold28	Wed, 22 September 2004 11:55
	Re: Gen2 to Gen 3 Turbos	mycress	Wed, 22 September 2004 18:06
	Re: Gen2 to Gen 3 Turbos	gold28	Thu, 23 September 2004 08:22

Previous Topic:	i need starlet engine info..
Next Topic:	gearbox weights

Powered by: FUDforum 2.3.8
Copyright ©2001-2003 Advanced Internet Designs Inc.