Toymods Car Club Inc: Members Rides => mr2 update for those intrested... dyno rsult

Toymods Car Club
www.toymods.org.au

F.A.Q.

Home

Members

Toymods » Members Rides » mr2 update for those intrested... dyno rsult Show: Today's Posts :: Show Polls Email to friend

Author

Topic

94mr2turbo
Regular

Location:
Prospect, Sydney
Registered:
April 2003

Re: mr2 update for those intrested... dyno rsult

Tue, 28 September 2004 08:31

MR. 2 wrote on Tue, 28 September 2004 16:45

no but i will get my hands on it now that i know...
yeah thats already on order the one with the billit steel cages and the inner.... i have them on order LOL no wasting time here... Also there isnt that much timming in the motor yet, just wanna make sure she runs right before we put more timming in it. Also have you had any issues with the axels before?? i was told by CV specialist that its because the car is lowered, and therefoer when it bogs down there is too much pressure, thats why its snaping! it makes sense but... ???? just no more burnouts until i have the stringer inners.

Good thinking!! That ATS kit should prevent any future problems. Your launch technique will also damage your axles. Dumping the clutch is a no no in my books, I slip it. I'd rather burn out a clutch than have to mess around with axles ever again. So yes, I have snapped axles before. When using some Nitto drag tyres from a friends race import, I ran my 11.96, and eventually burnt out the clutch and broke my axles shortly after on another launch attempt (not at track). Even with my output, breaking axles was inevitable, so in your case, it's an issue of when not if (that is if you're using standard axles, inners etc).

[Report message to a moderator]

[Message index]

-=] Back to Top [=-

Current Time: Sun Jul 27 03:52:36 UTC 2025

Total time taken to generate the page: 0.0080368518829346 seconds

.:: Contact :: Home ::.