| Author | Topic |
|---|
Location:
townsville NQLD
Registered:
February 2004
|
|
Re: mx62 crossmember in celica for 1g-gte conversion
|
Thu, 30 September 2004 00:11
|
 |
i think it has the same width between bolt holes. these are the cressida measurements, (730 or 740mm across and 105mm apart ie. front and back bolt) but it is hard to measure with a big dirty 5me still sittin in it and with a tape measure too. the ra40 xmember widthe between bolt centres is 745mm across and 115mm between front and back bolts. those measurements are correct for my ra40, but not so accurate for the cresdia. also i dont kno if the back of the xmember would fowl the steering drag link.
also i wouldnt kno if the suspension arm would be the same, i woul think it would be i dunno. i might sit lower or higher too.
anothere thing, maybe i could just use the mounts of the cressida, coz they seem lower, ands on a less steeper angle.
|
|
|
