Toymods Car Club Inc: Tech & Conversions => 20V head on 4agze (VALVE vs PISTONS)

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » 20V head on 4agze (VALVE vs PISTONS) Show: Today's Posts :: Show Polls Email to friend

Author

Topic

juzzo84
Forums Junkie

Location:
Hornsby, N.S.W
Registered:
September 2002

Re: 20V head on 4agze (VALVE vs PISTONS)	Sat, 09 October 2004 00:29

i think he want to place a 20v head on a gze bottom end for the sake of the stronger bottom end ( assuming for boost reasons ), but he is unsure if the vavles of the 20v head will clear the piston tops of the gze bottom end as there is only 4 vavles recessed into the tops of the gze pistons not 5.... my answer to the question is that there is not problem here, the reason there is cut outs in the pistons is so that if the timing belt is to break then the engine can freewheel without damaging anything, so if you are unluky enough to have the timing belt snap you may be in some trouble, this is the olny possilbe answer i can put toward your question, hope this helps, someone please correct me if im incorrect. Justin [Updated on: Sun, 10 October 2004 00:56] [Report message to a moderator]

Current Time: Fri Jul 25 18:28:40 UTC 2025

Total time taken to generate the page: 0.0044682025909424 seconds

.:: Contact :: Home ::.