| Author | Topic |
|---|
Location:
Canberra
Registered:
May 2002
|
|
Re: Oil Filter Relocation - Line Thickness
|
Wed, 10 November 2004 08:05
 
|
 |
| Quote: |
proper hydraulic lines I hope
|
Why hydraulic? Full oil system pressure should not exceed more than 100psi, hydraulic fittings/lines would surely be an unneccesary cost? 
1/2" (12.5mm) lines should be sufficient, or the nearest (larger) speedflow dash size depending on your choice of fittings. Are you planning an oil cooler as well? Try and keep your bends/lengths to a minimum. I assume this is for a 4AG?
Cheers
Phil
|
|
|
| | Subject | Poster | Date |
|---|
 |
Oil Filter Relocation - Line Thickness
|
takai | Wed, 10 November 2004 02:39 |
|
Re: Oil Filter Relocation - Line Thickness
|
b1gb3n | Wed, 10 November 2004 04:18 |
|
Re: Oil Filter Relocation - Line Thickness
|
1gt48u | Wed, 10 November 2004 04:20 |
|
Re: Oil Filter Relocation - Line Thickness
|
TE72_Turbo | Wed, 10 November 2004 08:05 |
|
Re: Oil Filter Relocation - Line Thickness
|
takai | Wed, 10 November 2004 08:52 |
|
Re: Oil Filter Relocation - Line Thickness
|
pro_ke | Wed, 10 November 2004 09:28 |
|
Re: Oil Filter Relocation - Line Thickness
|
takai | Wed, 10 November 2004 09:58 |
|
Re: Oil Filter Relocation - Line Thickness
|
10sec_rx7 | Wed, 10 November 2004 22:22 |
|
Re: Oil Filter Relocation - Line Thickness
|
TRD-ST162 | Thu, 11 November 2004 02:22 |
|
Re: Oil Filter Relocation - Line Thickness
|
Norbie | Thu, 11 November 2004 02:35 |
|
Re: Oil Filter Relocation - Line Thickness
|
EvilJack | Thu, 11 November 2004 02:40 |
|
Re: Oil Filter Relocation - Line Thickness
|
takai | Thu, 11 November 2004 03:13 |
