Toymods Car Club Inc: Tech & Conversions => Fitting Number Plate lights on AE86 CenterPiece

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » Fitting Number Plate lights on AE86 CenterPiece Show: Today's Posts :: Show Polls Email to friend

Author

Topic

shcao
Forums Junkie

Location:
Melbourne
Registered:
November 2002

Re: Fitting Number Plate lights on AE86 CenterPiece	Sun, 14 November 2004 03:51

shiri, you will have to drill a hole through the panel no matter what. I had to do it to mount my redlines. (where the tabs are held). I haven't relocated the liscence plates lights on bumper yet, because If I remove them, they'll be two huge gaps. I am gonna get it bogged up soon. To relocate those lights, you'll need the liscence plate lights off a JDM ae86. The ones on the back of the zenkis. Luckily, I think the ones on the CS ae82 sedans are the same. To do this, you need to drill a whole roughly with a 1.5 cm radius. Post some piccis of your car when you have finished. [Report message to a moderator]

Current Time: Sun Jul 20 06:15:27 UTC 2025

Total time taken to generate the page: 0.0038290023803711 seconds

.:: Contact :: Home ::.