Toymods Car Club Inc: Tech & Conversions => 4AGE-20 extractor design what's best

Toymods Car Club
www.toymods.org.au

F.A.Q.

Home

Members

Toymods » Tech & Conversions » 4AGE-20 extractor design what's best Show: Today's Posts :: Show Polls Email to friend

Author

Topic

Lucid
Forums Junkie

I supported Toymods
Toymods Club Secretary

Location:
Sydney
Registered:
May 2002

Re: 4AGE-20 extractor design what's best

Mon, 13 December 2004 10:32

oldcorollas wrote on Sun, 12 December 2004 18:44

mmm pretty, they look good. what is pipe length from head to first collectors?

Mate, I'll have to check on that for you next time i'm home and it's daylight.. Just to clarify - Do you mean the total length of the pipe (ie, what's pictured) or did you have something different in mind?

Sam_Q wrote

I thought they were just some cast manifold like the 16V. If I had a FWD I dont think I would be touching these.

Why's that? To me it seems like a much smoother design than the factory cast manifold!

Quote:

So heres a hard question for you, in factory spec do you know how long it is after the flange that the two outlets join together?

Nope - haven't seen the bottom half sorry Confused

Quote:

Also am i reading right that the primaries are 1 1/4 and the secondaries are 1 5/8, is that right?

Pretty much - I didn't get the exact figures, but the exit did definitely seem a little larger than the entry (makes sense I guess when there's two smaller pipes merging into one..

[Report message to a moderator]

[Message index]

-=] Back to Top [=-

Current Time: Tue Dec 24 16:25:16 UTC 2024

Total time taken to generate the page: 0.0071918964385986 seconds

.:: Contact :: Home ::.