| Author | Topic |
|---|
Toymods Vice President
Location:
Sydney
Registered:
May 2002
|
|
Re: Dyno configaration?
|
Thu, 16 December 2004 07:53
|
 |
What you're asking about in the initial question are two different things. SAE etc is just a calibration, basically it's the scale that the raw data is measured against.
As to the different Dyno's they do generate different results. As a general rule a dyno-jet will read less than 10% below the flywheel figures. A dyno-Dynamics will read around 30% lower than flywheel. Dyno-pac could read anything depending on the operator.
There are a multitude of other dyno manufacturers out there so you're never going to get a really good understanding of the results even from honest people.
|
|
|
