Toymods Car Club Inc: Tech & Conversions => High Pressure / Hydraulic Hoses

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » High Pressure / Hydraulic Hoses Show: Today's Posts :: Show Polls Email to friend

Author

Topic

gianttomato
Forums Junkie

I supported Toymods

Location:
I renounced punctuation
Registered:
May 2002

Re: High Pressure / Hydraulic Hoses	Fri, 17 December 2004 11:30

I have used Enzed and HIS with no grief, with HIS definitely being much better on price. Pirtek have been lazy (well my local one was anyway) such that I would recommend steering clear of them. Initially they can be difficult and tell you that the orientation of the fittings is very important. I would recommend you use swivel joints as the orientation becomes unimportant. Then it becomes a simple matter of bringing them the fittings at each end, a desired length from fitting end to fitting end and the use of a swivel joint. They will cut and braze the fittings. Ask them to fit the swivel joint at the most accessible point. I just had such a power steering line made for my Crown (1UZ power steering pump outlet to Commodore power steering rack - total length 800mm) for $81. [Report message to a moderator]

Current Time: Tue Jan 21 00:58:20 UTC 2025

Total time taken to generate the page: 0.0090818405151367 seconds

.:: Contact :: Home ::.