Toymods Car Club Inc: Tech & Conversions => Wanta turbo, or supercharge my 1990 camry

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » Wanta turbo, or supercharge my 1990 camry Show: Today's Posts :: Show Polls Email to friend

Author

Topic

da_horse
Regular

I supported Toymods

Location:
Melbourne Australia
Registered:
November 2003

Re: Wanta turbo, or supercharge my 1990 camry	Mon, 20 December 2004 02:16

i ish here project is still going forward, elbeit slowly as i build up funds so that i can do it properly. i'm also taking care of a few other modifications that i may need to before i do the conversion. parts wise you will need: st165/185/205 manifold and turbo and dumpipe. oil lines to and from turbo water lines to and from turbo (if you choose not to do this you will definately need a turbo timer) fuel management unit gaskets for manifold, oil lines etc Process wise: your engine needs to be in good nick, and due to the camry having a 9:1 compression ratio you have to realise that too high boost and you can say good bye to your engine. i'm actually goin to do a rebuild before i turbocharge the 3sfe and i'll be making sure that it will handle the boost. how many km's has your car done? have you got in mind what kind of fuel management you will be using? even if you just get a piggy back ECU and adjust some of the fuel mapping of stock ECU you will notice some increase, as the 3sfe has a slightly lean lower end, and after 5K rpm, it runs rich....if you adjusted it a bit so that the A/F ratio was more spot on then you would feel some difference. if your adamant on turbocharging then go for it but remember that you will need to spend some time tuning the a/f maps to ensure you dont end up with melted pistons. Cheers Huy:) [Report message to a moderator]

Current Time: Tue Dec 24 13:30:38 UTC 2024

Total time taken to generate the page: 0.0062339305877686 seconds

.:: Contact :: Home ::.