Toymods Car Club Inc: Tech & Conversions => Wanta turbo, or supercharge my 1990 camry

Toymods Car Club
www.toymods.org.au

F.A.Q.

Home

Members

Toymods » Tech & Conversions » Wanta turbo, or supercharge my 1990 camry Show: Today's Posts :: Show Polls Email to friend

Author

Topic

da_horse
Regular

I supported Toymods

Location:
Melbourne Australia
Registered:
November 2003

Re: Wanta turbo, or supercharge my 1990 camry	Mon, 20 December 2004 03:36

what kinda of rebuild was undertaken? general rebuild or complete tear down? i think for 6psi it should be fine... oil lines i'm going to be using a some st205 oil gear (pump, sump pickup, etc) so that saves me from tapping a hole into the stock sump. i'll have to get back to you in regards to where you would get the inflow line from, i know out flow is fine and easy as its just from the outlet on the turbo to the sump. cooling lines i was goin to tap a line from the water pump into the turbo and then out back into the radiator. but i'm not 100% sure of this yet as i havent got that stage yet. essentially just tap a line in from after the radiator then make the outlet line go back in before the radiator. i think you should understand that...kinda of if your not clear on any issue just let me know and i'll reclarify for you. any thoughts on fuel management? i'd also suggest an intercooler, just use a stock st185 one and you'll be fine. i think there was one on sale recently for $50...you might need to reweld the inlet/outlet but shouldnt be too much. there are a few other things you need to address too (eg wastegate acutation, get a BOV or a recirc valve etc.) its easy in concept but expect to spend at least 1000. i know parts alone for me is 600 for just the turbo and oil gear. also you'll need an exhaust shop to fabricate an exhaust system or you can ask for them to make a adaptor pipe from the dump pipe out let to your stock system (cheap option but i dont know if it will be effective). one other thing is that you need to realise the gearbox might not take the increase in power. i'm not sure what may happen, but keep it in mind. Cheers Huy [Report message to a moderator]

[Message index]

-=] Back to Top [=-

Current Time: Tue Dec 24 12:42:27 UTC 2024

Total time taken to generate the page: 0.0059590339660645 seconds

.:: Contact :: Home ::.