F.A.Q.    Register    Login    Home Members    Search

Toymods » Tech & Conversions » Running in a new motor Show: Today's Posts  :: Show Polls  Email to friend

Author	Topic
mr2drift Regular Location: qld Registered: October 2003	Re: Running in a new motor Sat, 01 January 2005 00:14 i've just taken delivery of my freshly rebuilt 4a for my car, and the instructions were fairly simple. its a balance, as to run in new cams its recommended to run the engine at idle for at least an hour, but that then causes glazing on the bores because of the new rings and not a lot of oil ect, so the advice i was given was simply a few hundred km of driving using various conditions, but limit the revs. hehe as my engine is built to rev out to more than 8000 rpm, it was suggested to limit run in revs to 5500-6000 rpm. it was stressed to me NOT to let the motor sit at idle for any long periods( over a minute or so) as this would lead to glazing in the bores. other than that he said to do as many full load pulls as possible in third gear, and after 4-500 km, do what i liked with it! [Report message to a moderator]

	Subject	Poster	Date
	Running in a new motor	andrew_mx83	Fri, 31 December 2004 12:40
	Re: Running in a new motor	people100	Fri, 31 December 2004 23:30
	Re: Running in a new motor	mick	Sat, 01 January 2005 00:00
	Re: Running in a new motor	mr2drift	Sat, 01 January 2005 00:14
	Re: Running in a new motor	ChuckLandwehr	Sat, 01 January 2005 05:01
	Re: Running in a new motor	jesseT18	Sat, 01 January 2005 05:30
	Re: Running in a new motor	mrshin	Sat, 01 January 2005 09:44
	Re: Running in a new motor	jeffro RA28	Sat, 01 January 2005 10:28
	Re: Running in a new motor	oldcorollas	Sun, 02 January 2005 00:58
	Re: Running in a new motor	brett_celicacoupe	Sat, 01 January 2005 10:56
	Re: Running in a new motor	ed_ma61	Sun, 02 January 2005 01:30
	Re: Running in a new motor	Kyosho	Sun, 02 January 2005 10:08
	Re: Running in a new motor	andrew_mx83	Fri, 07 January 2005 02:30
	Re: Running in a new motor	drift86levin	Fri, 07 January 2005 02:41

Previous Topic:	1JZ PCV Valve Diff
Next Topic:	MA61 coilovers: installed!

Powered by: FUDforum 2.3.8
Copyright ©2001-2003 Advanced Internet Designs Inc.