| Author | Topic |
|---|
Location:
Canberra
Registered:
May 2002
|
|
Re: 2TG Bearings in a 3TGTE?
|
Fri, 08 November 2002 09:59
 
|
 |
3T-C (T18) big end and main bearings can be used, but the big end bearings need the oil hole re-drilled as its about 7mm off from the one that is already there.
Its a good idea to change timing chains,they tend to stretch after many k's, and get noisey.
The short chain is 62 link same as 18R toyota, long chain is 102 link same as 4G52/4 datsun.
A head service wouldnt hurt either, I'm sure the valve guides & seals would be the same as some other toyota twin cam of that era. any head shop can resurface the valves & seats for a better seal too.
Cheers
Phil
|
|
|
