| Author | Topic |
|---|
I Supported Toymods
Location:
Sydney
Registered:
December 2002
|
|
Re: valves bending
|
Sat, 22 January 2005 07:05
 
|
 |
Apparently with a 0.8mm MLM head gasket you can get away with shaving about 2-3 thou off the head without causing interference between the pistons and valves.
Also most cams esp from HKS are just longer duration not higher lift so changing cam's in most cases shouldn't cause any problems with interference.
I discussed all this with Justen and a few other people who have rebuilt quite a few 3SGTE's so I have reason to believe what they have said is correct.
|
|
|
| | Subject | Poster | Date |
|---|
 |
valves bending
|
MR. 2 | Fri, 21 January 2005 09:04 |
|
Re: valves bending
|
CelicaRA45 | Fri, 21 January 2005 09:40 |
|
Re: valves bending
|
draven | Fri, 21 January 2005 10:22 |
|
Re: valves bending
|
Joshstix | Fri, 21 January 2005 10:49 |
|
Re: valves bending
|
MR. 2 | Sat, 22 January 2005 04:53 |
|
Re: valves bending
|
Toobs | Sat, 22 January 2005 07:05 |
|
Re: valves bending
|
Joshstix | Sat, 22 January 2005 07:54 |
