the TAs and RAs use the same ball joint... if the bottom half of the ball joints are the same diameter then thats sweet and ill use that and then all i have to do is figure out the tir rods situation...
also what i want to do is weld the steering arm tie rod hole and re-drill that smaller to fir the stock TA22 tie rod...
cause the TA22 has an inner and outer tie rod that screw into a shaft (so to say) then the other option i have is that i could use the MX73 tie rod and would need to fabricate a piece of metal XXXmm long and tapper one side to fit the MX73 outer tie rod and the TA22 tie rod connector/shaft
Sun, 23 January 2005 09:52
