| Author | Topic |
|---|
Location:
Brisbane
Registered:
May 2002
|
|
Re: does anyone know how to
|
Tue, 25 January 2005 05:46
 
|
 |
Incorrect on both counts.
The oil pressure light switch is just that, a switch - it's not going to provide any useful signal for a gauge. Remove the switch and replace it with the oil pressure sensor - you may need an adapter fitting if the thread is different, but that should be easy to source from Pirtek/Enzed/etc.
If you want to run an oil temp gauge as well there's no need to drill and tap a new hole (this would require pulling the engine apart first, a little excessive just to install a gauge) - you can run a T-piece off the the existing hole and connect both sensors to that. Once again a hydraulic fitting shop will be able to supply what you need, just take them the oil light switch and the sensors for your gauges and they'll work it out from there.
|
|
|
| | Subject | Poster | Date |
|---|
 |
does anyone know how to fit oil guages to a gz20?
|
indian | Tue, 25 January 2005 04:49 |
|
Re: does anyone know how to
|
fade-e | Tue, 25 January 2005 05:19 |
|
Re: does anyone know how to
|
indian | Tue, 25 January 2005 05:50 |
|
Re: does anyone know how to
|
Norbie | Tue, 25 January 2005 05:46 |
|
Re: does anyone know how to
|
dcving | Tue, 25 January 2005 06:03 |
|
Re: does anyone know how to
|
indian | Tue, 25 January 2005 06:08 |
|
Re: does anyone know how to
|
dcving | Tue, 25 January 2005 06:14 |
|
Re: does anyone know how to
|
EMP-2TG | Tue, 25 January 2005 11:51 |
|
Re: does anyone know how to
|
justcallmefrank | Wed, 26 January 2005 00:55 |
|
Re: does anyone know how to
|
draven | Wed, 26 January 2005 01:02 |
|
Re: does anyone know how to fit oil guages to a gz20?
|
Celica_John | Wed, 26 January 2005 08:31 |
|
Re: does anyone know how to fit oil guages to a gz20?
|
badboybubby | Tue, 19 April 2005 06:04 |
