Toymods Car Club Inc: Tech & Conversions => replacing 6a-f with 4a-ge

Toymods Car Club
www.toymods.org.au

F.A.Q.

Home

Members

Toymods » Tech & Conversions » replacing 6a-f with 4a-ge Show: Today's Posts :: Show Polls Email to friend

Author

Topic

SW20R
Forums Junkie

I supported Toymods

Location:
Sydney
Registered:
May 2002

Re: replacing 6a-f with 4a-ge

Sun, 02 June 2002 12:21

partyjase wrote on Sun, 02 June 2002 9:53 PM

damn fuel filter in basically the same spot so could just replace. also distributor on the right hand side near ur pod filter.

xcuse my ignorance.. but i thought there was only 1 loom - that being the electrics between engine and dash/lights/ignition/etc.

doesn't the pod filter get affected by heat soak in that position?

yep hehe..

http://members.optushome.com.au/xfad3r/ae82seca/Pict0003-4ac.jpg

the old might 4a-c push bike civic gli beater! hahaha

well if you read the diagram i suppose its 1 loom.. and i guess it would be? but i brought my engine with the loom intact so all i had todo was plug it to the computer which uses 2 connectors out of 3.. the 3rd plug would be the 2nd loom the chassis loom

yeah it does get affected by heat like that.. ill make a heat shield when i got time.. becuase i only drive it to the train station and back which is only 2kms away and no need to go long driving yet.. its just in the running stage thats all Smiley =

[Updated on: Sun, 02 June 2002 12:22]

[Report message to a moderator]

[Message index]

-=] Back to Top [=-

Current Time: Sun Jan 12 13:37:23 UTC 2025

Total time taken to generate the page: 0.010595083236694 seconds

.:: Contact :: Home ::.