| Author | Topic |
|---|
Location:
MELB
Registered:
November 2004
|
|
Re: WTB: ST165 GT4 Intake pipe.
|
Wed, 09 February 2005 06:23
 
|
 |
I had similar problems... I looked at fabricating my own to suit.. In the end due to sticking to group N rules, I bought off toyota, and strangly they did have the elbow I needed in stock interstate. Anyway, they are a pain to get, and Toyota charge a fortune.
If you Don't need/wan't to stay stock, it should be easy enough to find someone to fabricate what you need. Me, I would have it all re-made in Mandrel bent tube, rather than the round then oblong than round setup from the factory. Most Exhaust Places should be able to help make something like that, and cost should not be too bad. You will also end up with less air distortion, and better flow into the compressor housing.
Anyway.. Best of Luck!
[Updated on: Wed, 09 February 2005 06:24]
|
|
|
