| Author | Topic |
|---|
Location:
Bundaberg, Qld.
Registered:
May 2002
|
|
Re: fitting GZE pistons to bigport 4age?
|
Fri, 11 February 2005 20:22
 
|
 |
bugger. if it were a later 7 rib engine it would have the 20mm gudgeon pins.
you could swap the crank and rods from a later 7 rib 4age into your block, but then you might as well use the whole 7 rib engine with it's stronger block if you sourced the lot. or of course find a 4agze and be done with it.
if you got a bigport 4agze you wont need to swap your head over either. unless you wanted a the smallport 4agze because of it's higher c/r.
|
|
|
| | Subject | Poster | Date |
|---|
 |
fitting GZE pistons to bigport 4age?
|
Big T | Fri, 11 February 2005 11:14 |
|
Re: fitting GZE pistons to bigport 4age?
|
feral4mr2 | Fri, 11 February 2005 11:59 |
|
Re: fitting GZE pistons to bigport 4age?
|
Big T | Fri, 11 February 2005 12:43 |
|
Re: fitting GZE pistons to bigport 4age?
|
feral4mr2 | Fri, 11 February 2005 20:22 |
|
Re: fitting GZE pistons to bigport 4age?
|
Big T | Fri, 11 February 2005 21:51 |
|
Re: fitting GZE pistons to bigport 4age?
|
quest | Sat, 12 February 2005 00:50 |
|
Re: fitting GZE pistons to bigport 4age?
|
Big T | Sat, 12 February 2005 07:32 |
|
Re: fitting GZE pistons to bigport 4age?
|
Mr Revhead | Sat, 12 February 2005 10:40 |
|
Re: fitting GZE pistons to bigport 4age?
|
Big T | Mon, 14 February 2005 03:52 |
|
Re: fitting GZE pistons to bigport 4age?
|
Mr Revhead | Mon, 14 February 2005 20:45 |
