| Author | Topic |
|---|
I supported Toymods
Location:
I renounced punctuation
Registered:
May 2002
|
|
Re: MS65 hub installation to Corona MK2
|
Sun, 13 February 2005 06:49
 
|
 |
You will need to machine out the centre hole so the rotor fits on the back of the hub. You will also have to redrill the stud pattern so that you can bolt the rotor to the hub. Should be a few hours work at a machinist.
The MS65 hubs run the same bearings as the Mk2 Corona hubs. Fitting the hubs should be as straightforward as unnbolting the Mk2 hubs and sliding on the Crown hubs.
|
|
|
