Toymods Car Club Inc: Tech & Conversions => 7M-GTE rebuild

Toymods Car Club
www.toymods.org.au

F.A.Q.

Home

Members

Toymods » Tech & Conversions » 7M-GTE rebuild - need some help ? Show: Today's Posts :: Show Polls Email to friend

Author

Topic

bbaacchhyy
Forums Junkie

Location:
Adelaide
Registered:
September 2003

Re: 7M-GTE rebuild - need some help ?

Thu, 17 February 2005 03:12

Allan wrote on Thu, 17 February 2005 13:27

p.s 200rwkw is a little bit of a low target, if you stick a moderen compressor wheel in the ct26 with your larger intercooler and so forth 300 would be more like it.

Allan

The pistons I am looking at are Arais forged units, and their catalogue indicates that they are either 8.9 or 9.0
:1 and std bore.

The MHG that I have is a Cometic unit and is 0.051" thick (stock is 0.056" I beleive ?)

The turbo will be a T04B cored CT26, with a Super V trim compressor wheel (I believe that it is basically the same as a 57 trim) and a P trim turbine (so the exhaust has been bored out as well).

The 200 target was one that should be more than enough to embarass many cars, and still give scope for further increases when I get bored with that level.

Some more grunt should also be realised with the fitment of the LS1 MAF (& MAFT) in place of the std AFM !!

Cheers

Michael B

[Report message to a moderator]

[Message index]

-=] Back to Top [=-

Current Time: Tue Jul 29 15:42:41 UTC 2025

Total time taken to generate the page: 0.0034439563751221 seconds

.:: Contact :: Home ::.