| Author | Topic |
|---|
Location:
Adelaide
Registered:
June 2003
|
|
18RG Con Rod Identification
|
Tue, 01 March 2005 00:15
|
 |
Hello all,
I was looking over some parts I have, supposedly from an 18RG and just wanted to compare some spec to some other people's 18RG bits.
The questions were raised because my spares are not the same as the con rods in my brother's 18RGU.
Question: Which con rods are 18RG(U)(E) genuine parts?
My Brother's
On my brother's ones, on the side that has the old toytota emblem on the big end of the inner part of the I-beam, there is also a protruding square shape made into them that is closer to the middle of the I-beam section.
My Spares:
My spare con rods do not have this square shaped protrusion made into them.
On the reverse side, on the gudgeon pin end, they have cast into them: 942M
On the side of this set, there is a protruding line cast into them that is ~5mm wide on the beam section and ~7mm wide around the Gudgeon pin bushing hole.
They also have oil squirters on the big end and an oil hole in the Gudgeon bushing hole.
If you are 100% sure that you have 18RG(U)(E) conrods, could you please give me a description of any landmark features.
Likewise, if you are 100% sure that you have 18R (C) conrods, could you please give me a description of any landmark features on those.
My peace of mind depends on you.
Thanks.
Steve M
|
|
|
| | Subject | Poster | Date |
|---|
 |
18RG Con Rod Identification
|
Steve M | Tue, 01 March 2005 00:15 |
|
Re: 18RG Con Rod Identification
|
Scootaphill | Tue, 01 March 2005 04:34 |
|
Re: 18RG Con Rod Identification
|
Steve M | Tue, 01 March 2005 08:42 |
|
Re: 18RG Con Rod Identification
|
Steve M | Wed, 02 March 2005 02:37 |
|
Re: 18RG Con Rod Identification
|
barned01 | Wed, 02 March 2005 05:54 |
|
Re: 18RG Con Rod Identification
|
Steve M | Wed, 02 March 2005 14:00 |
|
Re: 18RG Con Rod Identification
|
jeffro RA28 | Thu, 03 March 2005 07:28 |
|
Re: 18RG Con Rod Identification
|
jeffro RA28 | Thu, 03 March 2005 08:09 |
|
Re: 18RG Con Rod Identification
|
Steve M | Thu, 03 March 2005 10:51 |
|
Re: 18RG Con Rod Identification
|
Mr DOHC | Mon, 07 March 2005 12:13 |
|
Re: 18RG Con Rod Identification
|
Steve M | Mon, 07 March 2005 13:53 |
|
Re: 18RG Con Rod Identification
|
Steve M | Sun, 22 May 2005 02:55 |
