| Author | Topic |
|---|
Location:
Sydney, OZ
Registered:
May 2002
|
|
Re: ae 101 shocks
|
Sun, 13 March 2005 02:05
|
 |
| Quote: |
THERE WAS DEFINATLY NO FLAPPING AS
|
Here we go again... another low brow... Read the fricking thread..= flapping. If the original's are Monroe that were released from toyota, KONI INSERTS DON'T FIT!! If the Vehicle has KYB's, which some do!! They will fit... It's quite clear he has Monroe, which at the top of the strut is wider than the bottom (around 10cm from the top you'll see it narrow in diameter on all four struts), Now if the struts you converted didn't do this ie same diameter straight down, their from a different model, most likely an AE92 or you may have a very, very early AE101, just after the change over from the AE92 where Toyota uses up all it's left overs from the earlier model. Now The new Monroes my supplier gave me while I sorted these issue out (remember back in "95 not much info on these back then) did the same, and similar the last ones I did Three week ago did the same and the koni we put in two months ago.... do i keep going? Regardless of you did it 12mth's ago I have been preparing and racing this exact model for close to Ten years now, Yes it does take around two hours, AS LONG AS YOU'VE GOT THE RIGHT SHOCKS!!!
|
|
|
