Toymods Car Club Inc: General Car Talk => Brisbane area engineer?

Toymods Car Club
www.toymods.org.au

F.A.Q.

Home

Members

Toymods » General Car Talk » Brisbane area engineer? Show: Today's Posts :: Show Polls Email to friend

Author

Topic

wilbo666
Forums Junkie

Location:
Brisbane
Registered:
May 2002

Re: Brisbane area engineer?

Fri, 18 March 2005 08:21

hickoz_bro wrote on Fri, 18 March 2005 16:45

thechuckster wrote on Sat, 25 September 2004 20:57

any suggestions for someone (in Brisbane) to engineer my conversion of a draw-thru turbo to EFI turbo using non-commercial_ECU (megasquirt)?

why would you bother with a draw through set up? from what i've heard it's all bad... you basically increase the volume for a bomb should the car backfire, you've got all the plumbing from the intake manifold through the cooler, turbo, and then throught the throttly body? and on top of that, you end up with the air fuel mixture running through the turbo... ie HOT, so the fuel is likely to condense, and therefore you don't get a good burn... hmmmmm... perhaps i'm completely arse about, but if there was any advantage to a draw through set up, i'm sure it'd be used more Confused

It actually reads that he's converting from a draw through carby/turbo setup to a turbo + EFI setup (mega squirt)....and he's not 100% sure if he'll have to get it mod plated or not Smile

Cheers
Wilbo

[Report message to a moderator]

[Message index]

-=] Back to Top [=-

Current Time: Thu Jan 23 09:40:06 UTC 2025

Total time taken to generate the page: 0.0091991424560547 seconds

.:: Contact :: Home ::.