Author | Topic |

Location: Adelaide, Semaphore
Registered: September 2004
|
Re: 4k engine queries
|
Fri, 25 March 2005 01:11

|
 |
Cold air induction will give you a slight performance increase, it is worth doing if you are due an air filter change. its not a cheap mod though, unless you go for cheap and nasty pvc tubing. Go down to your nearest Alloy stockist, they will have a huge range of alloy tubing to get you starte, and is relatively cheap. I got some to start making coil over kits, and found it to be something like $4/kg, a RamFlow pod could set you back in the near $80. I don't know what you will use for the bends, but someone else might know what to use on the end of the alloy tubing. Remember, you can polish up alloy to a mirror finish, and is a good heat conductor.
Good luck mate.
|
|
|