Toymods Car Club Inc: Tech & Conversions => QUESTIONS REGARDING Ke30 axles in a KE10 diff

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » QUESTIONS REGARDING Ke30 axles in a KE10 diff Show: Today's Posts :: Show Polls Email to friend

Author

Topic

On Probation

Location:
North East NSW
Registered:
December 2002

Re: QUESTIONS REGARDING Ke30 axles in a KE10 diff	Wed, 13 April 2005 11:13

hey. i've measured this up before, you can put ke30 axles into a ke20, but i think it'd be pretty touch and go into a ke10. the spline is tapering off when it would be needing to seat properly into the spider gears. i don't think you can do it, but you'd really have to try and see. knock one ke30 axle into an empty ke10 housing and see if it scores the splines yes, the backing plate pattern is totally different on ke10s, so you'd need to modify your drum backing plates and flanges, which is just as illegal as modifying caliper mounts or control arms on the front ke10 and 20 are different stud pattern to ke30 wheel tracks are on matti kalahati's site, but you can't swap any diffs without modifying the mounts some ke10 and 20 have a 5.7" diff center (X or B series cant remember) and some have 6" center (U series). stewart and i aren't 100% sure, but we both seem to remember something about the two being interchangeable in the housing, and it's just the ring gear sizes that are different, not the design of the pumpkin we had this discussion on oldrollas a while back. if you have a ke10, you're pretty much stuck with 4x110 on the back, unless you shorten a better diff and axles (like a T series celica diff) and weld leaf mounts to it [Report message to a moderator]

Current Time: Mon Jul 28 16:17:03 UTC 2025

Total time taken to generate the page: 0.0044639110565186 seconds

.:: Contact :: Home ::.